INSTALLATION
INSTALLATION VIDEO
Step by step installation instructions.
KEY LINKS
INSTALLATION
OVERVIEW
This is only an overview. Please download the full instruction manual (above right)
or watch the video (above left) for full installation instructions.
01
Read the Pre-Installation Checklist
02
WARNING
Do not attempt to install SkyBell in wet conditions. Do not proceed if you, SkyBell or the area around your door is
wet. SkyBell can only be attached to a low voltage transformer (12-36 VAC) and not directly to primary power
(110/120 VAC and 220/230/240 VAC).
If you do not use a doorbell chime, you MUST use a 10 ohm/10 watt
resistor between SkyBell and one wire from the power source. Resistor not included in packaging.
03
Remove current doorbell.
04
Screw baseplate into wall
05
Attach each SkyBell wire to a home doorbell
wire with the blue connectors. If no doorbell
chime, you must use a resistor.
See power diagrams for more info.
06
Place device on mounting plate, make sure device
is flush to wall.
07
Insert locking tool in small hole at bottom of device. Turn 3 whole rotations to the left to secure device in place. See video!
VIDEOS
Full Installation
Set Screw
Additional Wall Mounts - Coming Soon
Door Frame Adapter
Wedge Mount
